Battery impact tester

Product introduction

　　The test sample cell is placed on a flat surface with a 15.8±0.2mm（5/8 in） 

diameter rod placed in a cross position over the center of the sample. A 9.1kg or

10kg weight is dropped from a certain height （610mm or 1000mm） onto the 

sample. 

　　When the battery is subjected to impact test, its vertical axis should be parallel 

to the plane and perpendicular to the vertical axis of the steel column. The most 

axis of the square battery is perpendicular to the steel column, and the largest surface 

is perpendicular to the impact direction. Each battery receives only one impact test. 

The battery does not catch fire or explode.

Meet the standard

　　GBIT31485-2015 "Safety requirements and test methods of power Batteries for 

Electric Vehicles"

　　GB/T31241-2022 "Safety requirements for lithium-ion batteries and battery packs 

for portable electronic products.

　　UN383 United Nations Manual of Tests and Standards for the Transport of 

Dangerous Goods

　　IEC62133 "Safety requirements for batteries （groups） composed of cells and for 

use in portable equipment"

　　UL1642-2012 "Inner Battery Standard"

Main parameter

　　Inner box size :550x550x1440mm（W x D x H）

　　Equipment dimensions :660x900x1720mm（W x D x H）

　　Material :SUS201 stainless steel plate, thickness 1.2mm and coated with Teflon

　　Outer box material: 1.5mm thick cold rolled steel plate paint treatment

　　Observation window: 250x250mm tempered glass, transparent window with 

stainless steel mesh.

　　Lighting device: The machine is equipped with a light inside to facilitate the 

observation of the state of the tested sample.

　　Smoke outlet: 100mm in diameter, located at the rear of the box.

　　Pressure relief port: The opening size is 200x200mm, located at the back of the 

box. When the sample is exploded, the pressure relief port will pop open and remove 

the pressure.

　　Door: single door open left, door equipped with safety limit switch, side equipped 

with explosion-proof chain to ensure the safety of personnel.

　　Ball weight: 9.1kg, 10kg, 0.1kg

　　Impact height :0-1000mm, commonly used test height 610 —— 25mm

　　Control mode: touch screen control

　　Displacement accuracy: 5mm soil

　　Impact mode: lift the falling ball to a certain height and release it. The falling 

ball falls freely in the vertical direction without tilting or shaking.

　　Metal rod: Diameter 15.8±0.2mm steel rod

　　Maximum battery size :200x200x200mm

　　Impact surface :45# steel paint treatment, thickness 15mm

　　Equipment weight :270kg

　　Power supply :AC220V

　　Power :600W